Care guide
Love is unconditional. Muddy covers shouldn’t be. The cover zips off and goes in the machine, and this is everything you need to keep it looking its best.
Putting the cover on
The cover is a deliberately snug fit, so it sits neatly and gives a determined chewer less to grab. The first time takes a little patience. After that, it takes a minute or two.
The bolster
- Lay the cover flat on the floor and undo both zips.
- Line the bolster up on top of the cover, with the round side facing down so it goes in first.
- Find the anchor corner in the bolster section of the cover, and pull the short arm of the bolster through it. This is what keeps everything secure.
- Push the rest of the bolster into the inner section, line up the inner zip and zip the bolster in.
The mattress
- Find the blue memory foam side of the mattress. This side goes into the cover first, as it is the side closest to your dog.
- Push the mattress well into the corners for a snug fit.
- Zip the cover closed, and it is ready to use.
For a clean zip: push the foam in with one hand and run a finger just ahead of the zip with the other.
Still not sitting right? Email hello@mrtobias.co.uk or WhatsApp us and we will guide you through it.
Washing the cover
- Unzip the cover and take out the bolster and the mattress foam.
- Zip the cover closed again, so the zips do not catch in the drum.
- Wash on a gentle cycle at 30°C with a mild detergent. No bleach or fabric softener.
- Tumble dry on a gentle cycle, or air dry.
- Put the cover back on, following the steps above.
The foam
- The foam should never go in the machine.
- Each foam section has a moisture-resistant liner. If needed, wipe it clean with a damp cloth.
Between washes
Wash weekly or monthly, depending on use. Dogs who shed heavily or spend time outdoors may need it more often.
In between, the flat sleeping area hoovers easily and a lint roller freshens the bouclé.
For more on keeping a dog bed fresh, read our guide to washing a dog bed properly.